Owner Manual

Table Of Contents

Assembly instructions:

Step 1: Take a sling cable with soft pipe to wrap around the tree that will be used as the Starting Point. After

fully extending the turnbuckle, attach it to the eye loops of sling cable, then tighten the bolt and nut.

Step 2: Attach the other end of the turnbuckle to the eye loop of the zipline(main cable), tighten the bolt and

nut.

Note: To keep the sling cable from sliding down the starting point tree during installation, you may place a

small nail(not included) into the bark on the backside of the tree. Do not drive the nail trough the cable,

and remove nail after installation.

Step 3: Wrap the other end of the zipline with sping brake and soft pipe around your Finishing Point tree, set

your finishing point tree height.Lock the zipline with 2 U-clamps. (The zipline need to be relocked after tighten

it in Step 4 )

Tree

Step 4： Tighten the zipline

① Thread the end of the strap trough the slotted spool bottom of the ratchet and straighten the line.