Extra Information
EU COMPLIANCE INFORMATION
Eligible to bear the CE mark; Conforms to European Union Low 
Voltage Directive 2006/95/EC; European Union EMC Directive 
2004/108/EC; European Union Restriction of Hazardous Sub-
stances Recast (RoHS2) Directive 2011/65/EC; European Union 
WEEE Directive 2002/96/EC; European Union Eco-Design Direc-
tive 2009/125/EC; European Union Registration, Evaluation, 
Authorization and Restriction of Chemicals (REACH) Directive 
2006/121/EC; European Union Radio and Telecommunications 
Terminal Equipment (R&TTE) Directive 1999/5/EC.
This product contains batteries that are covered under the 
2006/66/EC European Directive, which cannot be disposed of 
with normal household waste.  Please follow local regulations. 
You may obtain a free copy of the Declaration of Conformity 
by contacting your dealer, distributor, or Klipsch Group, Inc.’s 
worldwide headquarters. Contact information can be found 
here: http://www.klipsch.com/Contact-Us
WEEE NOTICE
Note: This mark applies only to countries within the European 
Union (EU) and Norway.
This appliance is labeled in accordance with European 
Directive 2002/96/EC concerning waste of electrical 
and electronic equipment (WEEE). This label indicates 
that this product should not be disposed of with household 
waste. It should be deposited at an appropriate facility to 
enable recovery and recycling.
FCC AND CANADA EMC COMPLIANCE INFORMATION
This device complies with part 15 of the FCC Rules. Operation is 
subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) 
this device must accept any interference received, including 
interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply 
with the limits for a Class B digital device, pursuant to part 
15 of the FCC Rules. These limits are designed to provide 
reasonable protection against harmful interference in a 
residential installation. This equipment generates, uses and can 
radiate radio frequency energy and, if not installed and used in 
accordance with the instructions, may cause harmful interference 










