Owner's Manual Part 1

Disconnect the cable on your cable, satellite or HD set-top box that is
connected to your TV (you need to connect 1 video and 1 audio).
Connect the VIDEO—look at the options available on the set-top box
and choose 2A or 2B.
To maintain best picture quality—if the back of the set-top box
has any COMPONENT VIDEO (Y, PB, PR) OUTPUT jacks, plug
corresponding cable(s) into the jack(s) on the set-top box and to
the Klipsch CS700’S SAT/CBL/HD INPUT COMPONENT
jacks (Y to Y; PB to PB, PR to PR). If you use 2A, you must
also connect the corresponding output from the Klipsch controller’s
“VIDEO OUTPUT” section to your TV to ensure that you get a picture.
These cables have not been included with the Klipsch system.
When using the HDMI connection you must turn Progressive Scan
(7:*(5) “On”. If the HDMI connection are used and 7:*(5
is “Off”, you will not see a picture.
If the set-top box has a VIDEO (yellow) OUTPUT jack for video, plug
the supplied yellow video cable into that jack and to the Klipsch
system’s SAT/CABLE/HD INPUT COMPOSITE (yellow) jack.
1.
2.
*()3,05
6<;7<;:
=0+,6:=0+,6
*64765,5;
@ 7) 79
*()3,)6?ZOV^U
+0.0;(3
*6(?0(367;0*(3
(<+06
3 9
*()3,:0.5(3
69
69
69
2A
2B
3C
3B
3A
/+406<;
2307:*/*65;9633,9
STEP 3A: Set-Top Box Connection
Connect the AUDIO—look at the options available on the set-top box
and choose 3A, 3B, 3C.
Connect the supplied audio cables to the AUDIO LEFT (white) and
AUDIO R
IGHT
(red) jacks on the back of the set-top box and to the
Klipsch system’s SAT/CABLE/HD INPUT LEFT (white) and RIGHT
(red) jacks.
If the set-top box has Digital AUDIO (
COAXIAL ), connect appropri-
ate cable to the set-top box AUDIO COAXIAL jack and to the
SAT/CABLE/HD INPUT COAXIAL jack.
If the set-top box has Digital AUDIO ( OPTICAL ), connect appropriate
cable (not supplied) to the Klipsch System’s SAT/CABLE/HD INPUT
OPTICAL jack. You will first need to remove the plastic dust plug.
Note: If you connect a high definition Y, PB, PR INPUT, you must also
connect the corresponding Y, P
B, PR OUTPUT to your TV. If you connect
HDMI, you must also connect the corresponding output from the Klipsch
controller’s “VIDEO OUTPUT” section to your TV to ensure that you get a
picture. These cables have not been included with the Klipsch system.
3.
A.
B.
C.
Use this connection if your TV has a cable box, satellite receiver or HD receiver set-top box connected to it.
See next page (3B) if no set-top box is used.
A.
B.
Please see appendix I (page 28) for the basics on how input
and output jacks work with your Klipsch system.
Input and Output Jacks