Installation Manual Owner's manual

8
INSTALLATION CONTINUED（ ）
UNIT INSTALLATION (CONTINUED)
- Rotate the vent control lever to either open or close
the vent door.(See Fig.6)
Vent control lever
Vent open
Vent closed
Fig.6
- Lift unit level and slide unit into w all sleeve until
firmly against front of wall sleeve and secure w ith
4 screws and washers (supplied in the SLEEVE
ASSEMBLY ) through the unit flange holes.
(See Fig.7 and Fig.8)
- Reinstall front panel.(See Fig.9)
Fig.7
Fig.8
Fig.9
Place tabs over top rail . Push Inward at bottom
until panel snap s into place .
NOTE:When vent control lever set at CLOSE,on ly
the air inside the room is circulated and filtered.
When set at OPEN,some outdoor air will be drawn
into room.This will reduce heat ing or cooling
efficiency.
!
CAUTION
Do not put obstacles around air-inlet or
inside of air-outlet of the unit, such as window
curtain etc.
Always insert the filter securely, clean filter once
every two weeks as required.