User manual

7
PRECAUTIONS
1. The dehumidifier shall not operate if the humidity setting is higher than the ambient humidity.
2. Drain the water in the water storage tank when the water in the tank is full and the water level
indicator light illuminates. And then install the empty water tank back to its position, so the unit can
continue its operation.
3. When the unit stops, you have to wait for 3 minutes before you can restart the unit to protect the
compressor from damage.
4. The humidify and its related position number on the humidity control switch:
CONTROL SWITCH
POSITION NO.
APPROXIMATE
HUMIDITY SETTING
8
20﹪
7
30﹪
6
40﹪
4
60﹪
2
80﹪
5. The operational temperature range for this unit is 15-35. The dehumidifier will not work
effectively outside this range. Please see “Physical Basics”. In the low temperature area is only
few water in the air. So the dehumidification is lower then by higher temperature.
6. If the dehumidifier does not start (the operational light does not illuminate) or the dehumidifier
makes intermediate stop on unknown reasons, please check the plug and power supply for poor
connection. If the plug and power supply are in normal condition, wait for 10 minutes and restart
the unit (because take about 10 minutes to reposition). If the unit still does not starts in 10 minutes,
please contact your local distributor service station for repair.
7. When the dehumidifier is in operation, the running compressor will produce heat and make the
room temperature higher. This is normal
condition.