User manual TOM600 Item partnumber : 61-200-0600 SURFACE RESISTIVITYMETER EUROSTAT TOM600 The Surface Resistivimeter EUROSTAT 600 operates with the Voltage-Current-Measurement.
User manual TOM600 Item partnumber : 61-200-0600 List of contents 1. Description 3 2. Operation Instruction 3 3 4 4 2.1 2.2 2.3 3. Set – Up Functions 3.1 3.2 4. Measure Voltage / Display Mode Timer Other Display Information’s 4.1 5. Start up Charging the battery Measureranges and Voltage Display Contrast PC – Operating 5.1 5.2 5.3 system requirements Softwareinstallaion Starting the Software 4 5 6 6 6 7 7 7 7 6. Warranty 7 7. Specifications 7 8. Safety Advice 7 9.
User manual TOM600 Item partnumber : 61-200-0600 1. Description The surface resistivimeter EUROSTAT TOM600 is suitable very well for the mobile use in industrial areas through its compact housing and through the battery power. It can also be used stationary with a plug power supply. Important: Don’t use the AC-Adapter when rechargeable batteries are installed. The EUROSTAT 600 is menu-controlled, has only two buttons and so it is very operator-friendly. All parameters are shown at the LC - Display.
User manual TOM600 Item partnumber : 61-200-0600 * mathematical representation of technical representation < 2TΩ * * Alternating to the timer display T=OFF is shown the measure voltage mode: Auto, 100V or 10V To turn off the appliance press again key B . In the battery mode the unit turns off , if no button was pressed, automatically after approximately 5 minutes. 2.2. Charging the NiMH Battery The EUROSTAT TOM600 allowed only to operating directly with the enclosed power supply.
User manual TOM600 Item partnumber : 61-200-0600 By pressing key (B) „Change“ it appears T= 002s and than in 1 second Steps up to10 Second. After that the timer starts with T=010s the changing steps are now 10 Seconds up to 60 Seconds, after this you get 60 second steps up to 240 seconds. Press the (A) „Set-Up“ key to choose the displayed timer time. At the display appears: TIMER MODE : AVERAGE (LAPSE) By pressing key (B) „Change” the timer is switching between AVERAGE and LAPSE.
User manual TOM600 Item partnumber : 61-200-0600 Now the unit will execute a reset, and in the display appears if timer is on, else go to point 3.2 Timer off. T=xxxs Avg Auto (Lap) (+10V, +100V) PRESS START ! By pressing key (A) „Start” the next measurement will be started. The timer decrements in 1 second steps up to Zero, then the measure value will appears in the display as Ravg by AVERAGE - Mode and Rlap by Lapse – Mode. In the 2nd line the air temperature and the humidity is displayed: Ravg = 2.
User manual TOM600 Item partnumber : 61-200-0600 The accumulator must be charged again, but the current measurement can be completed. If the Battery Voltage is lower as 4.3 volts the following display appear and the unit automatically switches off, to save the batteries. LOWEST BATTERY ! AUTO SWITCH OFF ! 4.1 Display contrast On the front side left from the PC – Interface there is a hole trough this you can screw a potentiometer for adjust the Contrast of the LCD - Display. 5. PC – Operating 5.
User manual TOM600 Item partnumber : 61-200-0600 Power Supply 8. Operating time of the completely charged battery: > 12 hours of continuous operation Charge time with enclosed power adapter: maximum 14 hours : 9V-DC / 300 mA Safety Advice The measurement unit is not approved for the use in explosive areas! The unit is not approved for the use in power utilities! Info: Make sure, that there is no voltage on your measuring.
User manual TOM600 Item partnumber : 61-200-0600 • Ring Electrode to EOS/ESD S 11.11 + DIN EN 61340 –5-1, -2-3 comprising to the measurement of transit and surface resistances, 1 shielded and 1 no shielded Measure cord. other electrodes are available on inquiry 11. Maintenance / Calibration The appliance is maintenance-free. If the appliance should get dirty , it can be cleaned with a lint-free cotton cloth with solvent-free detergent. Don’t open the housing.
User manual TOM600 Item partnumber : 61-200-0600 13. How to install the tester It is preferable to connect the smallest cord on the yellow side (amplifier side) and the long cord on the red side.
User manual TOM600 Item partnumber : 61-200-0600 11
