Owners manual

PLEASE NOTE:
RUSTED TANKS CAN FAIL CAUSING EXPLOSIONS OR FATAL INJURIES.
Discard tank immediately if tank is rusted.
When using a safety pressure relief valve, point the safety pressure relief valve away
from your body when releasing air. Use the pull ring on the safety relief valve; open the
relief valve to vent any pressure inside the tank before servicing tank.
Tank Fittings:
Install the supplied compression fittings and/or quick connect fitting for the air tank in
areas where they are most appropriate for your installation using thread sealant or Teflon
tape. Make sure that the safety valve is installed in the top most position on the tank, and
that the drain cock is installed in the lowest position on the tank if the tank is to be
installed in any other position than upright on the tank’s mounting legs. Be sure that all
fittings are accessible later in the installation process since you will have to plumb air
lines to each fitting as needed to utilize the air tank.
6350RC Air Compressor Installation
Your system comes complete with a model 6350, 100% duty cycle compressor. Please
follow the installation instructions that follow to enjoy the best use of your onboard air
system. (Use contents of Package # 2 for this installation step)
CAUTION - To reduce risk of electrical shock or electrocution:
• Do not disassemble the compressor. Do not attempt repairs or modifications. Refer
to qualified service agencies for all service and repairs.
• Do not use this product in an area where it can fall or be pulled into water or liquids.
• Do not reach for this product if it has fallen into liquid.
• Use this compressor with 12-volt DC systems only.
• This product should never be left unattended during use.
Guidelines for Selecting Mounting Location:
The selection of proper mounting location for your air compressor will help ensure a long
and trouble free compressor service life. Please pay close attention
to the following:
• Select a flat and secure location where the compressor can be mounted. The 6350RC
can be mounted in any position, however, we do not recommend mounting it upside
down, as this can cause excessive heat build-up.
• To maximize air compressor performance, locate compressor as close to the battery
as possible so that length of positive lead wire required is at a minimum.
• Choose mounting location that is as cool as possible and away from heat sources.
• This compressor is moisture & dust resistant, but NOT WATERPROOF or DUST
PROOF. Do not mount compressor in locations such as behind a tire, where the unit
is likely to come in contact with excessive water or dirt. The 6350RC may be
mounted underneath your vehicle as long as you use the remote air intake kit that is
included with the system and relocate the air intake. When using the remote intake,