Owners manual

6. Repairs should be performed by Manufacturer or Manufacturer’s Authorized Service
Agencies only.
CAUTION: Never touch the air compressor or fittings connected to the air compressor
with bare hands during or immediately after use. Leader hose and fittings will become
very HOT during and after use.
Compressor Installation Tips
1. Use the remote intake filter option whenever possible. This will extend the service
life of your compressor.
2. If noise reduction from vibration is desired, using the remote mount option for the
inlet filter can reduce operation noise by up to 25%.
3. Always mount the compressor at a point higher than the inlet port of the tank. This
will keep moisture from being able to seep back to the tank.
4. When mounting the compressor, use a paint pen on the rubber isolators. Then, simply
stamp the compressor against the chassis to make an imprint of exactly where to drill
the mounting holes for the compressor.
Pressure Switch Installation
Your system requires the use of a pressure switch that will turn the compressor on & off.
The use of a 40-amp, 4-post relay is strongly suggested to prolong the pressure switch life
span. The 6350RC air compressor is rated to 150 PSI maximum working pressure. Wire
the air compressor like this:
Pressure Switch & Relay Installation Tips
1. Never install a pressure switch in direct line from the inlet port coming from the
compressor. Tank pressure can be misread by the pressure switch. Instead, mount the
pressure switch on the tank where it receives readings from deflected air in the tank.
2. Never use a pressure switch that is rated beyond your compressor’s rated Maximum
Working Pressure (150 PSI).
3. Always use a relay to turn the compressor on and off. This will increase the life of the
pressure switch. (Note: Relay wiring diagram above.)
4. Each lead of the pressure switch is a (+) power lead. One lead is connected to the
power lead on your compressor, and the other is routed to a fused, switched power.