Owners manual

 Select a flat and secure location where the compressor can be mounted. The 6350RC
can be mounted in any position; however, we do not recommend mounting it upside
down, as this can cause excessive heat build-up.
 To maximize air compressor performance, locate compressor as close to the battery
as possible so that length of positive lead wire required is at a minimum.
 Choose mounting location that is as cool as possible and away from heat sources.
 This compressor is moisture & dust resistant, but NOT WATERPROOF or DUST
PROOF. Do not mount compressor in locations such as behind a tire, where the unit
is likely to come in contact with excessive water or dirt. The compressor may be
mounted underneath your vehicle as long as you use the remote air intake kit that is
included with the system and relocate the air intake.
 When using the remote intake, select compressor’s mounting location where air line
can be routed from compressor air inlet to remote inlet air filter. Make sure that the
remote inlet air filter is located in a dry location, away from water. You will also
want to select a compressor mounting location where the leader hose bracket can be
mounted to secure the stainless steel braided leader hose.
 If it is necessary to mount the air compressor further from the battery, such as inside
your vehicle or in the bed of your pickup, use a minimum 8 AWG positive lead wire
for remote installation.
 Do not mount compressor near areas where flammable liquids are stored.
Compressor Wiring:
1. Disconnect ground cable from vehicle’s battery.
2. Temporarily position the air compressor in the location where it will be mounted.
3. Route ground wire to the negative post of the battery or to an appropriate grounding
point and cut ground wire to length as needed.
4. Mount the air compressor with the four sets of 13/64” (5 mm) bolts, nuts, washers,
and locking washers provided. Use of thread locker is recommended.
5. NOTE: For Remote Inlet Air Filter Installation, use all components included in the
Remote Inlet Air Filter Pack.
6. This air compressor comes with a heavy duty heat resistant stainless steel braided
leader hose with ¼” NPT fittings. This leader hose is designed to prolong the life of
your air line. Do not remove this leader hose from air compressor.
7. IMPORTANT: Please note; the leader hose that came with your compressor has a
built-in inline check valve. Do not remove inline check valve from leader hose.
8. Select a proper location to mount leader hose with hose bracket provided. Avoid
locations where leader hose may become tangled with wires and other hoses.
9. To mount hose bracket, drill holes with 3/16” drill bit and push self–anchoring hose
bracket pin into hole. Route leader hose through hose bracket and secure hose by
pressing bracket clamp into locked position.
10. To remove hose from the hose bracket, simply press down on the hose clamp release
tab to release bracket clamp.
11. Connect compressor’s positive lead wire to one of the leads of your pressure switch.
12. Make sure that your compressor setup is properly fused. The compressor pulls
approximately 16 amps of power maximum.
13. Always locate fuse as close as possible to power source.