Model 6350RC 100% Duty Cycle Compressor IMPORTANT: It is essential that you and any other operator of this product read and understand the contents of this manual before installing and using this product.
Model 6350RC Components: 1 Model 6350RC Kleinn Air Compressor (Please check to make sure that you have three labeled packages in your kit. Each package contains the parts needed for specific areas of onboard air installation, and may contain smaller bags within each package labeled for specific use.
Select a flat and secure location where the compressor can be mounted. The 6350RC can be mounted in any position; however, we do not recommend mounting it upside down, as this can cause excessive heat build-up. To maximize air compressor performance, locate compressor as close to the battery as possible so that length of positive lead wire required is at a minimum. Choose mounting location that is as cool as possible and away from heat sources.
14. Before connecting to power source, check to make sure that all connections are made properly. 15. Connect and test compressor system by running the compressor for a short time to build up pressure in your air tank. 16. Once air pressure reaches the preset cut out pressure of your pressure switch, the compressor will shut off. Inspect all air line connections for leaks with soap and water solution. If a leak is detected, the air line may not be cut squarely or pushed all the way in.
6. Repairs should be performed by Manufacturer or Manufacturer’s Authorized Service Agencies only. CAUTION: Never touch the air compressor or fittings connected to the air compressor with bare hands during or immediately after use. Leader hose and fittings will become very HOT during and after use. Compressor Installation Tips 1. Use the remote intake filter option whenever possible. This will extend the service life of your compressor. 2.
Testing Your System Your system installation is now complete. Run the compressor to build pressure in the air tank. When air pressure reaches the pressure switch cut out pressure, the compressor will shut off. Inspect all air line connections for leaks by spraying a soap and water solution on them and looking for bubbles. If leaks are detected, re-attach hoses or apply Teflon thread tape as needed.