Model 6270 130 PSI Compressor with 1-Gallon Air Tank 12VDC IMPORTANT: It is essential that you and any other operator of this product read and understand the contents of this manual before installing and using this product.
Model 6270 Components: 1 1 1 1 1.0 Gallon, 5-port air tank Model 6270RC compressor Package air fittings Package mounting hardware (Please check to make sure that you have two packages in your kit. Each package contains the parts needed for specific areas of onboard air installation, and may contain smaller bags within each package labeled for specific use.
Qty 1 Leader Hose Bracket Clip Qty 1 Air line for remote mounting air filter Qty 2 Nuts, bolts, and washers – (Air tank mounting hardware) 1.0 Gallon Air Tank Installation Your 1.0 Gallon air tank comes with five 1/4” NPT port openings to allow a variety of installation configurations in your vehicle. To insure safe and trouble-free use of your air tank, we strongly recommend that you install the supplied drain cock and a safety pressure relief valve.
RUSTED TANKS CAN FAIL CAUSING EXPLOSIONS OR FATAL INJURIES. Discard tank immediately if tank is rusted. When using a safety pressure relief valve, point the safety pressure relief valve away from your body when releasing air. Use the pull ring on the safety relief valve; open the relief valve to vent any pressure inside the tank before servicing tank.
• • inlet to remote inlet air filter. Make sure that the remote inlet air filter is located in a dry location, away from water. You will also want to select a compressor mounting location where the leader hose bracket can be mounted to secure the 2 ft. leader hose. If it is necessary to mount the air compressor further from the battery, such as inside your vehicle or in the bed of your pickup, use a minimum 10 AWG positive lead wire for remote installation.
COMPRESSOR OPERATING INSTRUCTIONS IMPORTANT: The compressor has a maximum working pressure of 130 PSI and is capable of 15% duty cycle. It is designed for use with air horns, air bags and other accessories that utilize the compressed air stored in the tank. It is not designed for continuous use applications such as tire inflation or air tools. Always operate the compressor at or below the MAXIMUM PRESSURE RATING of the compressor.
Compressor Installation Tips 1. Always use the remote intake filter option when possible. This will extend the service life of your compressor. 2. If noise reduction from vibration is desired, using the remote mount option for the inlet filter can reduce operation noise by up to 25%. 3. Always mount the compressor at a point higher than the inlet port of the tank. This will keep moisture from being able to seep back to the tank. 4.
Air Tank Layout Note: Your setup may look different if your tank is mounted in a position other than what is shown above.
Kleinn Model 6270 LIMITED WARRANTY Kleinn Automotive Air Horns warrants this product, when properly installed and under normal conditions of use, to be free from defects in workmanship and materials for a period of one year from provided date of purchase. To receive a replacement or for repairs, return the complete unit to retailer from whom it was purchased along with proof of purchase. Returns should be made within the time period and conditions of the retailer’s policy for exchanges.
