Owners manual

87
85
86
30
87a
Battery
Pressure Switch
Compresor (+) Power Wire
Connect to a SWITCHED
+12v power source
(turns on/off with the
iginition key)
Ground
Pressure Switch
Installation Instructions
1) The pressure switch gets installed on the air tank. It has
a 1/8" Male NPT thread. If your tank does not have a 1/8"
port, we have adapters available for purchase in all sizes
2) Apply either teflon tape or a liquid sealant to the threads
to prevent air leaks.
3) The pressure switch must be installed in a port that is
NOT at the bottom of the tank. If it is installed at the bottom
of tank, the normal moisture that condenses in the tank will
enter the pressure switch and cause it to fail.
4) For best results, locate the pressure switch so that it is
not directly opposte the port that has the air input from the
compressor.
Kleinn Air Horns 2094 N. Dragoon St
Tucson, AZ 85745 [phone]
www.kleinn.com