Instructions / Assembly

10
COAX CABLE PROPERLY WIRED:
ID
Pass
COAX CABLE WITH AN OPEN:
Open
COAX CABLE WITH A SHORT:
Short
NOTE: An
open fault
will also
occur when
no remote is
connected to
the satellite
end of a video/
coax cable.
WIRE MAP AND DISPLAY EXAMPLES
ENGLISH
1. Loosen screw ion battery cover with #2 Phillips screwdriver.
2. Remove battery door.
3. Disconnect battery cable and recycle exhausted battery.
4. Install fresh 9 volt alkaline battery.
5. Connect battery cable to new battery observing polarity and place into battery compartment.
6. Replace battery door and secure with screw, taking care not to over-tighten.
WARRANTY
www.kleintools.com/warranty
CLEANING
Turn instrument off and disconnect any cables. Clean the instrument by using a damp cloth.
Do not use abrasive cleaners or solvents.
STORAGE
Remove the batteries when instrument is not in use for a prolonged period of time. Do not expose
to high temperatures or humidity. After a period of storage in extreme conditions exceeding the
limits mentioned in the Specifications section, allow the instrument to return to normal operating
conditions before using it.
DISPOSAL / RECYCLE
Do not place equipment and its accessories in the trash. Items must be properly disposed
of in accordance with local regulations. Please see www.epa.gov or www.erecycle.org
foradditional information.
BATTERY REPLACEMENT
KLEIN TOOLS, INC.
450 Bond Street Lincolnshire, IL 60069 1-800-553-4676
www.kleintools.com
CUSTOMER SERVICE
Use for cable location identification mapping and continuity testing.
Remotes display on tester asRemote IDs #1-12.
UPGRADE REMOTES
RJ45 port F-connector port
REMOTE ID # PART #
1 VDV501-211
2 VDV501-212
3 VDV501-213
4 VDV501-214
5 VDV501-215
6 VDV501-216
7 VDV501-217
8 VDV501-218
9 VDV501-219
10 VDV501-220
11 VDV501-221
12 VDV501-222
TEST + MAP™ ID REMOTES (VDV501-2## SERIES)