User Guide

SRAM CORPORATION • APRIL 2005 11
SRAM CORPORATION • SID USER MANUAL ENGLISH
SRAM CORPORATION WARRANTY
Extent of Limited Warranty
SRAM warrants its products to be free from defects in materials or workmanship for a period of
two years after original purchase. This warranty only applies to the original owner and is not
transferable. Claims under this warranty must be made through the retailer where the bicycle or
the SRAM component was purchased. Original proof of purchase is required.
Local law
This warranty statement gives the customer specific legal rights. The customer may also have
other rights which vary from state to state (USA), from province to province (Canada), and from
country to country elsewhere in the world.
To the extent that this warranty statement is inconsistent with the local law, this warranty shall be
deemed modified to be consistent with such law, under such local law, certain disclaimers and
limitations of this warranty statement may apply to the customer. For example, some states in the
United States of America, as well as some governments outside of the United States (including
provinces in Canada) may:
a. Preclude the disclaimers and limitations of this warranty statement from limiting the statutory
rights of the consumer (e.g. United Kingdom).
b. Otherwise restrict the ability of a manufacturer to enforce such disclaimers or limitations.
Limitations of Liability
To the extent allowed by local law, except for the obligations specifically set forth in this warranty
statement, In no event Shall SRAM or its third party supplies be liable for direct, indirect, special,
incidental, or consequential damages.
Limitations of Warranty
- This warranty does not apply to products that have not been incorrectly installed and/or adjusted
according to the respective SRAM technical installation manual. The SRAM installation manuals can be
found online at www.sram.com or www.rockshox.com.
- This warranty does not apply to damage to the product caused by a crash, impact, abuse of the product,
non-compliance with manufacturers specifications of usage or any other circumstances in which the
product has been subjected to forces or loads beyond its design.
- This warranty does not apply when the product has been modified.
- This warranty does not apply when the serial number or production code has been deliberately altered,
defaced or removed.
- This warranty does not apply to normal wear and tear. Wear and tear parts are subject to damage as a
result of normal use, failure to service according to SRAM recommendations and/or riding or
installation in conditions or applications other than recommended.
WEAR AND TEAR PARTS ARE IDENTIFIED AS:
• Dust seals • Bushings
• Air sealing o-rings • Glide rings
• Rubber moving parts. • Foam rings
• Rear shock mounting hardware • Upper tubes (stanchions)
and main seals
• Stripped threads/bolts (aluminium, • Brake sleeves
titanium, magnesium or steel)
• Brake pads • Chains
• Sprockets • Cassettes
• Shifter and brake cables (inner and outer) • Handlebar grips
• Shifter grips • Jockey wheels
• Disc brake rotors • Tools
- This warranty shall not cover damages caused by the use of parts of different manufacturers.
- This warranty shall not cover damages caused by the use of parts that are not compatible, suitable
and/or authorised by SRAM for use with SRAM components.
10 954-311120-000, REV.B
ENGLISH SRAM CORPORATION. • SID USER MANUAL
SERVICE INTERVALS
Judy 1/2
Judy 3/4
Clean dirt and debris from upper tubes E E
Inspect upper tubes for scratches E E
Lubricate dust seals/tubes 1010
Check top caps, brake posts and shaft
bolts for proper torque
25 25
Check air pressure * *
Remove lowers, clean/inspect
bushings and change oil bath
*50
Change oil in Motion Control System * *
Clean and lubricate Air U-Turn/Dual
Air/Air Assist assembly/Solo Air
**
Clean and lubricate coil spring or coil
U-Turn spring assembly
100 100
Clean and lubricate PopLoc cable and
housing
**
All 32mm XC
& All Mountain
Air Forks
SID Race, SL
& World Cup
Clean dirt and debris from upper tubes
E
E
E
Inspect upper tubes for scratches
E
E
E
Lubricate dust seals/tubes
10
10
10
Check top caps, brake posts and shaft
bolts for proper torque
25
25
25
Check air pressure
E
E
*
Remove lowers, clean/inspect
bushings and change oil bath
50
50
50
Change oil in Motion Control System
100
100
100
Clean and lubricate Air U-Turn/Dual
Air/Air Assist assembly/Solo Air
50
50
*
Clean and lubricate coil spring or coil
U-Turn spring assembly
*
*
100
Clean and lubricate PopLoc cable and
housing
50
50
50
Notes:
E = Every ride
Numeric values represent hours of riding time.
Increase service intervals based on rider weight, aggressive riding style/conditions, inclement weather and racing
E
25
*
25
Boxxer Ride.
Race & Team
E
E
50
50
*
*
All 32mm XC
& All Mountain
Coil Forks
E
25
E
25
Boxxer
World Cup
E
E
50
25
*
*