MSDS

09/27/2010Revision:
01/09/2014Printed:
3
Klean Strip Odorless Mineral Spirits
SAFETY DATA SHEET
Page:
6. Accidental Release Measures
Steps To Be Taken In Case Material Is Released Or Spilled
Isolate the immediate area. Prevent unauthorized entry. Eliminate all sources of ignition in area and downwind of
the spill area. Stay upwind, out of low areas, and ventilate closed spaces before entering. All equipment used
when handling this product must be grounded or non-sparking. Do not touch or walk through spilled material.
Stop leak if you can do so without risk. Prevent entry into waterways, sewers, or confined areas. A vapor
suppressing foam may be used to reduce vapors. Absorb or cover with dry earth, sand, or other non-combustible
material and transfer to compatible containers. For large spills, dike ahead of the spill for possible collection and
reuse or disposal.
7. Handling and Storage
Precautions To Be Taken in Handling
Read carefully all cautions and directions on product label before use. Since empty container retains residue,
follow all label warnings even after container is empty. Dispose of empty container according to all regulations.
Do not reuse this container.
Do not use near any source of heat or open flame, furnace areas, pilot lights, stoves, etc.
Ensure all equipment is electrically grounded before beginning transfer operations.
Avoid prolonged skin contact.
Precautions To Be Taken in Storing
Keep container tightly closed when not in use. Store in a cool, dry place. Do not store near any source of heat or
open flame, furnace areas, pilot lights, stoves, etc.
8. Exposure Controls/Personal Protection
200 mg/m3No data. No data.
Hazardous Components (Chemical Name) ACGIH TLV
Hydrotreated light distillate (petroleum) 64742-47-8
CAS # OSHA PEL Other Limits
1.
Respiratory Equipment (Specify Type)
For use in areas with inadequate ventilation or fresh air, wear a properly maintained and properly fitted NIOSH
approved respirator for organic solvent vapors.
For OSHA controlled work places and other regular users - Use only with adequate ventilation under engineered
air control systems designed to prevent exceeding the appropriate TLV.
A dust mask does not provide protection against vapors.
Eye Protection
Chemical splash goggles should be worn to prevent eye contact.
Protective Gloves
Wear gloves with as much resistance to the chemical ingredients as possible. Glove materials such as nitrile
rubber may provide protection. Glove selection should be based on chemicals being used and conditions of use.
Consult your glove supplier for additional information. Gloves contaminated with product should be discarded
and not reused.
Other Protective Clothing
Various application methods can dictate use of additional protective safety equipment, such as impermeable
aprons, etc., to minimize exposure. Before reuse, thoroughly clean any clothing or protective equipment that has
been contaminated by prior use. Discard any clothing or other protective equipment that cannot be
decontaminated, such as gloves or shoes.
Licensed to W.M. Barr and Company
GHS format