MSDS

04/16/2015Revision:
04/16/2015Printed:
Page: 3
Less Flammable Paint Thinner for SCAQMD
SAFETY DATA SHEET
03/27/2015Supersedes Revision:
4. FIRST AID MEASURES
Skin:
Immediately begin washing the skin thoroughly with large amounts of water and mild
soap, if available, while removing contaminated clothing. Seek medical attention if
irritation persists.
Eyes:
Immediately begin to flush eyes with water, remove any contact lens. Continue to flush
the eyes for at least 15 minutes, then seek immediate medical attention.
Inhalation:
Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get immediate medical attention.
Ingestion:
If swallowed, do NOT induce vomiting. Seek immediate medical attention. Call a
physician, hospital emergency room, or poison control center immediately. Never give
anything by mouth to an unconscious person. If spontaneous vomiting is about to occur,
place victim's head below knees. If victim is drowsy or unconscious, place on the left
side with head down.
Emergency and First Aid
Procedures:
5. FIRE FIGHTING MEASURES
Flash Pt:
No data. Method Used: Setaflash Closed Cup (Rapid Setaflash)
Self-contained respiratory protection should be provided for fire fighters fighting fires in
buildings or confined areas. Storage containers exposed to fire should be kept cool with
water spray to prevent pressure build-up. Stay away from heads of containers that have
been exposed to intense heat or flame.
Fire Fighting Instructions:
Product has a flash point of 106 F, but will not sustain combustion.
Flammable Properties and
Hazards:
Autoignition Pt:
No data.
Explosive Limits:
LEL: No data. UEL: No data.
Will not sustain combustion.
Use water spray, dry chemical, carbon dioxide, or alcohol-resistant foam.
Suitable Extinguishing Media:
Solid streams of water may be ineffective and spread material.
Unsuitable Extinguishing
Media:
6. ACCIDENTAL RELEASE MEASURES
Isolate the immediate area. Prevent unauthorized entry. Eliminate all sources of ignition
in area and downwind of the spill area. Stay upwind, out of low areas, and ventilate
closed spaces before entering. All equipment used when handling this product must be
grounded or non-sparking. Do not touch or walk through spilled material. Stop leak if
you can do so without risk. Prevent entry into waterways, sewers, or confined areas. A
vapor suppressing foam may be used to reduce vapors. Absorb or cover with dry earth,
sand, or other non-combustible material and transfer to compatible containers. For large
spills, dike ahead of the spill.
Steps To Be Taken In Case
Material Is Released Or
Spilled:
Licensed to W.M. Barr and Company: MIRS MSDS, (c) A V Systems, Inc.
GHS format