SDS

04/17/2015Revision:
04/17/2015Printed:
Page: 4
Klean-Strip Brush Cleaner / Paint Clean Up
VOC Compliant
SAFETY DATA SHEET
03/17/2015Supersedes Revision:
Waste Disposal: Dispose in accordance with applicable local, state and federal
regulations.
Keep out of drains, sewers, and bodies of water.
7. HANDLING AND STORAGE
Read carefully all cautions and directions on product label before use. Since empty
container retains residue, follow all label warnings even after container is empty.
Dispose of empty container according to all regulations. Do not reuse this container.
Do not use this product near any source of heat or open flame, furnace areas, pilot
lights, stoves, etc.
Do not use in small enclosed spaces, such as basements and bathrooms. Vapors can
accumulate and explode if ignited.
Precautions To Be Taken in
Handling:
Keep container tightly closed when not in use. Store in a cool, dry place. Do not store
near flames or at elevated temperatures.
Precautions To Be Taken in
Storing:
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
OSHA TWA ACGIH TWACAS # Partial Chemical Name Other Limits
PEL: 1000 ppm TLV: 500 ppm
STEL: 750 ppm
67-64-1 Acetone {2-Propanone}
No data.
PEL: 150 ppm TLV: 150 ppm
STEL: 200 ppm
123-86-4 Butyl acetate {n-Butyl acetate. Acetic
acid, Butyl ester}
No data.
For OSHA controlled work place and other regular users. Use only with adequate
ventilation under engineered air control systems designed to prevent exceeding
appropriate TLV.
For occasional use, where engineered air control is not feasible, use properly maintained
and properly fitted NIOSH approved respirator for organic solvent vapors. A dust mask
does not provide protection against vapors.
Respiratory Equipment
(Specify Type):
Safety glasses, goggles or face shields are recommended to safeguard against potential
eye contact, irritation, or injury.
Eye Protection:
Wear gloves with as much resistance to the chemical ingredients as possible. Glove
materials such as natural rubber and neoprene may provide protection. Glove selection
should be based on chemicals being used and conditions of use. Consult your glove
supplier for additional information. Gloves contaminated with product should be
discarded and not reused.
Protective Gloves:
Various application methods can dictate use of additional protective safety equipment,
such as impermeable aprons, etc., to minimize exposure.
Other Protective Clothing:
Use only with adequate ventilation to prevent build-up of vapors. Open all windows and
doors. Use only with a cross ventilation of moving fresh air across the work area. If
strong odor is noticed or you experience slight dizziness, headache, nausea, or
eye-watering - Stop - ventilation is inadequate. Leave area immediately.
Engineering Controls
(Ventilation etc.):
Wash hands thoroughly after use and before eating, drinking, or smoking.
Do not eat, drink, or smoke in the work area.
Discard any clothing or other protective equipment that cannot be decontaminated.
Work/Hygienic/Maintenance
Practices:
Licensed to W.M. Barr and Company: MIRS MSDS, (c) A V Systems, Inc.
GHS format