Operation Manual
Table Of Contents
- IMPORTANT
- Section 1 ACCESSORIES
- Section 2 PREPARATION
- Section 3 BASIC OPERATION
- Section 4 ADVANCED OPERATION
- Section 5 SCAN OPERATION
- Section 6 MENU SCREEN
- Section 7 NXDN™ OPERATION
- NXDN™ system operation
- Transmitting a call
- Receiving a call
- Roaming function (For Multi-site Trunking operation)
- Site Lock function (For Multi-site Trunking operation)
- Site Select function (For Multi-site Trunking operation)
- Incoming list
- Outgoing list
- Encryption function
- Over The Air Programming (OTAP) function
- Section 8 MDC 1200 SYSTEM OPERATION
- Section 9 BIIS 1200 SYSTEM OPERATION
- Section 10 VOICE RECORDER FUNCTIONS
- Section 11 Bluetooth® OPERATION
- Bluetooth® Wireless Technology operation
- Turning ON the Bluetooth® function
- Pairing with a headset or a data device
- Headset settings
- Accepting a pairing request from a Bluetooth® device
- Disconnecting from a Bluetooth® device
- Deleting a Bluetooth® device from the pairing list
- Resetting the installed Bluetooth® unit
- The maximum number of paired devices
- Section 12 OTHERS
- Section 13 OPTIONS
8
MDC 1200 SYSTEM OPERATION
8-10
After receiving an MDC Sel Call, Call Alert call,
or Emergency call, the call log may be displayed,
depending on the presetting� Up to 5 calls can be
memorized, and the oldest call is deleted when a 6th
call is received�
D Checking the Incoming call log
(Menu > Signaling/Call > Incoming)
1� Push [Menu] to display the Menu screen�
2� Push [P2 (Up)] or [P1 (Down)] to select “Signaling/
Call,” then push [OK]�
Channel/Scan ►
Signaling/Call ►
Menu
3� [P2 (Up)] or [P1 (Down)] to select “Incoming,” then
push [OK]�
Incoming ►
INDIV Select ►
Signaling/Call
• Incoming log is displayed�
ID 1
ID 1
Incoming
L If there is no log, an error beep sounds and the
following screen is displayed�
►
No Log
Incoming Call log function
The “Voice/Call Alert” screen is displayed�
L “ ” is for the Individual calls�
L “ ” is for the Call Alert calls�