Operation Manual
Table Of Contents
- IMPORTANT
- Section 1 ACCESSORIES
- Section 2 PREPARATION
- Section 3 BASIC OPERATION
- Section 4 ADVANCED OPERATION
- Section 5 SCAN OPERATION
- Section 6 MENU SCREEN
- Section 7 NXDN™ OPERATION
- NXDN™ system operation
- Transmitting a call
- Receiving a call
- Roaming function (For Multi-site Trunking operation)
- Site Lock function (For Multi-site Trunking operation)
- Site Select function (For Multi-site Trunking operation)
- Incoming list
- Outgoing list
- Encryption function
- Over The Air Programming (OTAP) function
- Section 8 MDC 1200 SYSTEM OPERATION
- Section 9 BIIS 1200 SYSTEM OPERATION
- Section 10 VOICE RECORDER FUNCTIONS
- Section 11 Bluetooth® OPERATION
- Bluetooth® Wireless Technology operation
- Turning ON the Bluetooth® function
- Pairing with a headset or a data device
- Headset settings
- Accepting a pairing request from a Bluetooth® device
- Disconnecting from a Bluetooth® device
- Deleting a Bluetooth® device from the pairing list
- Resetting the installed Bluetooth® unit
- The maximum number of paired devices
- Section 12 OTHERS
- Section 13 OPTIONS
7
NXDN™ OPERATION
7-13
D Receiving a Stun, Kill or Revive
If a Stun or Kill command is received, the transceiver
will display “Deactivated” and you cannot receive or
transmit.*
Deactivated
If a Stun command is received, you cannot operate
the transceiver until a Revive command is received, or
the password is input�
If a Kill command is received, you cannot operate the
transceiver until it is reprogrammed�
NOTE: Depending on the presetting, the transceiver
can ignore the Stun, Revive and Kill commands that
are from a non-specied station.
* Depending on the presetting, reception may be enabled.
D Receiving an Emergency call
When an Emergency call is received:
• Beeps sound�
• “RX Emergency” and the calling station name (or ID)
are alternately displayed�
• “ ” blinks�
RX Status 01
Call Scan
• When the Send Ack function is set to ON by
presetting, the transceiver automatically transmits an
acknowledgment to the calling station, if the received
call type is a Group or All call�
L If the received call type is Individual, and it requests
an acknowledgment be sent back, the transceiver
automatically sends the acknowledgment�
1� Hold down [PTT] to speak�
2� Turn OFF the transceiver, change the channel, or
push [PTT] or a key to stop the beep and display
indication�
Receiving a call