Operation Manual
Table Of Contents
- IMPORTANT
- Section 1 ACCESSORIES
- Section 2 PREPARATION
- Section 3 BASIC OPERATION
- Section 4 ADVANCED OPERATION
- Section 5 SCAN OPERATION
- Section 6 MENU SCREEN
- Section 7 NXDN™ OPERATION
- NXDN™ system operation
- Transmitting a call
- Receiving a call
- Roaming function (For Multi-site Trunking operation)
- Site Lock function (For Multi-site Trunking operation)
- Site Select function (For Multi-site Trunking operation)
- Incoming list
- Outgoing list
- Encryption function
- Over The Air Programming (OTAP) function
- Section 8 MDC 1200 SYSTEM OPERATION
- Section 9 BIIS 1200 SYSTEM OPERATION
- Section 10 VOICE RECORDER FUNCTIONS
- Section 11 Bluetooth® OPERATION
- Bluetooth® Wireless Technology operation
- Turning ON the Bluetooth® function
- Pairing with a headset or a data device
- Headset settings
- Accepting a pairing request from a Bluetooth® device
- Disconnecting from a Bluetooth® device
- Deleting a Bluetooth® device from the pairing list
- Resetting the installed Bluetooth® unit
- The maximum number of paired devices
- Section 12 OTHERS
- Section 13 OPTIONS
5
SCAN OPERATION
5-2
A Scan checks for signals on each channel and stops
when a signal is received�
NOTE: Two or more channels must be preset to start
a Scan�
(Menu > Channel/Scan > Scan ON/OFF)
1� Push [Menu] to display the Menu screen�
2� Push [P2 (Up)] or [P1 (Down)] to select “Channel/
Scan,” then
push [OK]�
Channel/Scan ►
Signaling/Call ►
Menu
3� Push [P2 (Up)] or [P1 (Down)] to select “Scan ON/
OFF,” then
push [OK]�
Scan List ►
Scan ON/OFF ►
Channel/Scan
4� Push [Up] or [Down] to select “ON,” then push
[OK]�
✔ OFF
✔ ON
Scan ON/OFF
SCAN ON/OFF
ON
• The Scan starts�
• “Scan ON/OFF ON” is briey displayed.
L When a signal is detected, the Scan pauses on the
channel until the signal disappears, then the Scan
resumes�
5� Hold down [Back] for 1 second to return to the
standby screen�
• “ ” blinks while scanning� (Depending on the
transceiver version�)
Starting a Scan