Operation Manual
Table Of Contents
- IMPORTANT
- Section 1 ACCESSORIES
- Section 2 PREPARATION
- Section 3 BASIC OPERATION
- Section 4 ADVANCED OPERATION
- Section 5 SCAN OPERATION
- Section 6 MENU SCREEN
- Section 7 NXDN™ OPERATION
- NXDN™ system operation
- Transmitting a call
- Receiving a call
- Roaming function (For Multi-site Trunking operation)
- Site Lock function (For Multi-site Trunking operation)
- Site Select function (For Multi-site Trunking operation)
- Incoming list
- Outgoing list
- Encryption function
- Over The Air Programming (OTAP) function
- Section 8 MDC 1200 SYSTEM OPERATION
- Section 9 BIIS 1200 SYSTEM OPERATION
- Section 10 VOICE RECORDER FUNCTIONS
- Section 11 Bluetooth® OPERATION
- Bluetooth® Wireless Technology operation
- Turning ON the Bluetooth® function
- Pairing with a headset or a data device
- Headset settings
- Accepting a pairing request from a Bluetooth® device
- Disconnecting from a Bluetooth® device
- Deleting a Bluetooth® device from the pairing list
- Resetting the installed Bluetooth® unit
- The maximum number of paired devices
- Section 12 OTHERS
- Section 13 OPTIONS
11
Bluetooth
®
OPERATION
11-11
You can reset the installed Bluetooth unit� You should
reset the unit if you have some troubles during
Bluetooth operation�
(Menu > Bluetooth > Bluetooth Reset)
1� Push [Menu] to display the “Menu” screen�
2� Push [P2 (Up)] or [P1 (Down)] to select
“Bluetooth,” then push [OK]�
Bluetooth ►
Vibration ►
Menu
3� Push [P2 (Up)] or [P1 (Down)] to select “Bluetooth
Reset,” then push [OK]�
Bluetooth ►
Bluetooth Reset ►
Bluetooth
4� Push [P2 (Up)] or [P1 (Down)] to select <OK>,
then push [OK]�
R Are u Sure?
Cancel
OK
Success
• Resets the Bluetooth unit’s settings to their factory
defaults�
5� Hold down [Back] for 1 second to return to the
standby screen�
NOTE: Before resetting, the Bluetooth function must
be turned OFF� Otherwise, resetting cannot be done�
Resetting the installed Bluetooth
®
unit