Quick Start Guide

28 29Quick Start GuideVNET USB RS232 INTERFACE
4. Repeat 2 and 3 for the other side. Now push the lid towards the back of the unit as far as it
will go then align the bracket ears with the front edge of the lid.
Now tighten the screws.
5. Oer the Accessory with its mounting brackets up
to the reverse side of the Mounting Panel, and x it inplace using the two sets of screws,
washers and nuts removed in 1.
Note that the holes at the rear ends of the brackets may be used as cable tie-o points
if desired.