Quick Start Guide SENTINEL SM1 VNET Monitoring Unit for Networked PA/VA Systems
SENTINEL SM1 Important Safety Instructions Terminals marked with this symbol carry electrical current of sufficient magnitude to constitute risk of electric shock. Use only high-quality professional speaker cables with ¼" TS or twist-locking plugs pre-installed. All other installation or modification should be performed only by qualified personnel.
4 SENTINEL SM1 Consignes de sécurité Les points repérés par ce symbole portent une tension électrique suffisante pour constituer un risque d’électrocution. Utilisez uniquement des câbles d’enceintes professionnels de haute qualité avec fiches Jack mono 6,35 mm ou fiches à verrouillages déjà installées. Toute autre installation ou modification doit être effectuée uniquement par un personnel qualifié.
6 SENTINEL SM1 Instruções de Segurança Importantes Aviso! Terminais marcados com o símbolo carregam corrente elétrica de magnitude suficiente para constituir um risco de choque elétrico. Use apenas cabos de alto-falantes de alta qualidade com plugues TS de ¼" ou plugues com trava de torção pré-instalados. Todas as outras instalações e modificações devem ser efetuadas por pessoas qualificadas.
8 SENTINEL SM1 Quick Start Guide Introduction Product description Sentinel SM1 System Monitor provides a complete system wide fault monitoring and reporting solution for mission-critical applications. Built on a tried and trusted processing “Engine”, Sentinel keeps a watchful eye on the audio system, and if required, any controlling PCs. Problems are reported both via relay contacts to the main monitoring panel in your system as well as being shown on Sentinel’s front panel display, and buzzers.
10 SENTINEL SM1 Quick Start Guide Utility A Fault incident looks like this: Relay A: Three terminals whose default action is to indicate when there is a PC disconnection fault. When there is no PC Fault the COM terminal is disconnected from the “N/O” terminal, and connected to the “N/C” terminal. When a PC Fault is present, the COM terminal becomes disconnected from the “N/C” terminal, and connected to the “N/O” terminal.
12 SENTINEL SM1 Quick Start Guide Monitoring section (MonIcon) Keyboard shortcuts This allows you to view what is going on inside the device and in the system at a glance. PodWare supports the following “shortcuts” : It shows the overall state of the monitored system, effectively duplicating some of the indicators on the device itself: Tab Move to next control • The System State (Normal, Check or Fault).
14 SENTINEL SM1 Quick Start Guide 15 Other important information Specifications Connectors Misc System Utility Network 2 x 3-pin phoenix 2 x 3-pin phoenix 2 x 3-pin phoenix 2 x RJ45 Display Main display LEDs Current status/check/fault condition history System normal (green) PC online (green) PC fault (amber) Check system (amber) System fault (amber) Power Switch-mode power supply Power consumption Mains connection Autorange 100-240 V (50/60 Hz) 30 W Standard IEC cable Physical Standard opera
16 SENTINEL SM1 Quick Start Guide FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE INFORMATION KLARK TEKNIK SENTINEL SM1 Responsible Party Name: MUSIC Group Research UK Limited Address: Klark Industrial Park, Walter Nash Road, Kidderminster. Worcestershire. DY11 7HJ. England.
