Manual
Pa
ge
4 Pa
ge
5
Operation
Once the Covert Camera is in place and aligned with the receiver, you must con-
nect the receiver to a monitor and/or video recorder to gain access to your video
footage.
1. To view video footage on a monitor or television, connect the unattached
end of the RCA video cable into the video input jack on your monitor or tele-
vision.
To record video footage, connect the unattached end of the RCA video cable
into the video input jack on your VCR or video recorder according to manu-
facturer’s instructions
.
2. Change the video input or auxiliary input for your monitor or recorder until
video footage can be viewed. The input select button is usually located on the
unit’s remote control or on the front panel of the unit itself. However, some
units may require you to select the video input from the on-screen menu.
Therefore, consult the owner’s manual for your monitor or video recording
device for specific instructions.
If using a recorder, check video transmission by connecting another RCA ca-
ble from the video output jack on the recorder to a monitor or television.
3. Your monitor should now display the view from the Covert Camera. Make
any necessary adjustments to the receiver antenna for best reception.
Tip: If picture quality is not optimum, try selecting an alternative channel.
Channel Selection
Your wireless transmitter and receiver have channel-select capabilities on four
channels. In order to capture video, transmitter and receiver must be on the
same channel.
1. To change the channel on the transmitter, push the black channel button
found inside ????????????? .
The unit is initially set to channel 1. Push the button once for channel 2,
twice for channel 3, or three times for channel 4.
2. To change the channel on the receiver, simply slide the channel select
switch of the appropriate channel down. All other channel switches must
remain up, as only one channel per camera may be selected.
NOTE: If your picture is going on and off every three to five seconds, you
may have inadvertently selected more than one channel. Adjust switches
to be sure that you have selected only one channel.
To use the receiver with multiple cameras, slide all of the appropriate
channel select switches, one per camera, into the down position. The re-
ceiver is auto-switch capable and should now switch every three to five
seconds between selected channels.
Safety Precautions
- Use only the included power supply to operate your wireless surveillance
system.
- To avoid electrical shock, do not attempt to open the unit.
- To prevent fire or shock hazard, do not expose this product to rain or
moisture. Do not operate near bath tub, sink, or swimming pool. Avoid
operation in moist environments.
- Do not overload electrical outlets or extension cords as this may result in
fire or electric shock.