Manual

Page 6
p
a
ge
3
General Setup Wireless Covert Camera 1. Install the Exit Sign Camera on a flat surface facing your target area. When
determining the best possible site selection, pay particular attention to lighting. It is always best to have the lighting on or in front of your subject instead of behind it.
2. Plug the power cord of the alarm clock into the nearest 110V AC outlet. Your
wireless covert camera should now be operating
.
2.4 GHZ Receiver 1. Position the receiver within 150ft – 300 ft ( see LOS) of the covert camera.
For optimal performance, adjust the 2.4 GHz antenna on the receiver. Alt- hough the units will still work properly without facing each other, transmis- sion range may be decreased.
2. Plug the included AC adaptor into a 110V wall outlet. Plug the 2.5mm male
power plug coming from AC adaptor into the back of the receiver. Red LED will come on to indicate power.
3. Connect the male yellow RCA cable plug into the female yellow RCA jack
located on the front of the receiver. (See Figure 1)
VIDEO
Figure 1