Manual

Operation
Once the Wireless Wall Clock Camera is in place and aligned with
the receiver, you must connect the receiver to a monitor and/or
video recorder to gain access to your video footage.
1. To view video footage on a monitor or television, connect
the unattached end of the RCA video cable into the video input
jack on your monitor or television.
To record video footage, connect the unattached end of the
RCA video cable into the video input jack on your VCR or
video recorder according to manufacturer’s instructions
.
2. Change the video input or auxiliary input for your monitor or
recorder until video footage can be viewed. The input select
button is usually located on the unit’s remote control or on the
front panel of the unit itself. However, some units may require
you to select the video input from the on-screen menu.
Therefore, consult the owner’s manual for your monitor or
video recording device for specific instructions.
If using a recorder, check video transmission by connecting
another RCA cable from the video output jack on the recorder
to a monitor or television.
3. Your monitor should now display the view from the Wall
Clock Camera. Make any necessary adjustments to the
receiver antenna for best reception.
Tip: If picture quality is not optimum, try selecting an alternative
channel.
Channel Selection
Your wireless transmitter and receiver have channel-select
capabilities on four channels. In order to capture video,
transmitter and receiver must be on the same channel.
1. To change the channel on the transmitter, push the red
channel button found inside the battery compartment on the
bottom of the clock radio.
The unit is initially set to channel 1. Push the button once for
channel 2, twice for channel 3, or three times for channel 4.
2. To change the channel on the receiver, simply slide the
channel select switch of the appropriate channel down. All
other channel switches must remain up, as only one channel
per camera may be selected.
NOTE: If your picture is going on and off every three to five
seconds, you may have inadvertently selected more than one
channel. Adjust switches to be sure that you have selected
only one channel.
To use the receiver with multiple cameras, slide all of the
appropriate channel select switches, one per camera, into the
down position. The receiver is auto-switch capable and
should now switch every three to five seconds between
selected channels.
Safety Precautions
- Use only the included power supply to operate your wireless
surveillance system.
- To avoid electrical shock, do not attempt to open the unit.
- To prevent fire or shock hazard, do not expose this product
to rain or moisture. Do not operate near bath tub, sink, or
swimming pool. Avoid operation in moist environments.
- Do not overload electrical outlets or extension cords as this
may result in fire or electric shock.