Manual

Operating the Clock
Insert one fresh “AA” size battery into the battery holder in back of
the clock according to the diagram inside the battery compartment.
Alkaline type batteries strongly recommended.
Setting Clock Time
Turn the hand setting knob on back side of the clock in a clockwise
or counter clockwise direction.
NOTE: As soon as clock slows suddenly or stops, indicating a
weak or exhausted battery, remove the battery at once and replace
to prevent battery leakage and subsequent damage to the clock.
We are not responsible for damage caused by a leaking battery.
General Setup
Wireless Covert Camera
1. Place the Wall Clock Camera on a flat surface facing your
target area. When determining the best possible site
selection, pay particular attention to lighting. It is always
best to have the lighting on or in front of your subject instead
of behind it.
2. Plug the included 12V AC adaptor into a 110V wall outlet.
Plug the 2.5mm male power plug of the 12V adaptor into the
power plug leading from the Wall Clock Camera. Your
wireless covert camera should now be operating
.
2.4 GHZ Receiver
1. Position the receiver within 150ft – 300ft ( see LOS) of the
covert camera. For optimal performance, adjust the 2.4 GHz
antenna on the receiver. Although the units will still work
properly without facing each other, transmission range may
be decreased.
2. Plug the included 9V AC adaptor into a 110V wall outlet.
Plug the 2.5mm male power plug coming from 9V AC
adaptor into the back of the receiver. Red LED will come on
to indicate power.
3. Connect the male yellow RCA cable plug into the female
yellow RCA jack located on the front of the receiver. (See
Figure 1)
Figure 1
VIDEO