Installation Instructions

Administrator Functions • 19
• Tap Sync Now, the clock will start the update process and return
the default screen when finished.
Date/Time Setup
This menu allows you to manually configure the time zone, DST and how
the hours will display on the clock.
At the clock tap the Settings button and enter the administrator PIN.
• The Administrator Menu screen will display.
• Tap Date & Time and make the desired changes.
• When finished tap to return to the default screen.
Signal-Door Access
This menu allows you to configure how the clock uses the on-board
relay.
At the clock tap the Settings button and enter the administrator PIN.
• The Administrator Menu screen will display.
• Tap Signal-Door Access. The signal-door access screen will
display.
• Select the Relay Mode.
o Off – The relay is disabled.
o Access – The relay will be used to activate a door strike
allowing employees to enter the facility.
o Signal – The relay will open/close to sound the signaling
device.
• The Schedule button will display if Signal is selected. Press
Schedule and enter the bell events. Up to 100 events can be
programmed.
• Select the duration to for the relay. By default, it is set at 5
seconds.
• Use the Test button to activate the on-board relay to test the
connection.
• When finished tap to return to the default screen.
See Appendix F for steps to add/edit/delete bell events.