Manual

21
3) Measure a
pproximately 6 metres of line, and then thread one end through the
hole on the spool. Pull the line until the two line lengths are equal (See Fig. W).
Fig. W
4) Wind both lines tightly and evenly from side to side and feed the line while
turning the spool in the direction of the arrow - winding clockwise. Do not allow
the lines to become twisted (See Fig. X).
Fig. X
It is important to prevent the two lines from becoming twisted with each other.
Position a finger between the lines as you turn the spool to prevent any twisting.
5) Wh
en you have about (6 inches) 150mm of line remaining, press the line into the
two notches on the bottom of the spool. This will hold the line on the spool for
re-assembly (See Fig. Y).
Fig. Y