Data Sheet

WS2812B LED
Intelligent control LED integrated light source
10/9
leakage phenomenon,Please use directly, can don’t do the bake dehumidification.
2. During use, please open a bag and use a bag,please don’t open many bags at one-time
which shall lead the LEDs absorb moisture in the air since you don’t use them at once.
3. After SMT,please do the reflow soldering furnace immediately,please don’t leave them in
in the pre-reflow for a long time which absorb moisture.Especially
when off work,please use out the LEDs which is out of packaging,please SMT and
reflow,do not let them stay in the air for a long time.
4. Dehumidification process,please under 70-75
℃
, bake for 24 hours. Also note during
using, use the LEDs immediately after taking out of the bake box,please don’t take many
reels at one-time, since it is very hot when taking out,LED in the cooling process more
easily absorb the moisture in the air into the inside of the LED ,which shall cause led dead
during reflow.
5.Please pay attention that it is forbidden to secondary reflow soldering.