Manualshelf

Data Sheet

ManualsBrandsKitronik Manualsmicro:bit AccessoriesKitronik MOVE Mini Robot Kit (w/o micro:bit)
11121314151617181920
18
STEP 3: Snap the pen mounting plate in between the two vertical plates, just
above the servo. The servo cables should pass out of the rear of the chassis.
ASSEMBLING THE CHASSIS
6
STEP 1: Slot the servo into the base plate with
the shaft facing out, and the wires facing up. This
should fit very tightly and may require some
pressure to snap into place.
STEP 2: Slot the side part over the top of the servo,
ensuring the panel sits in front of blue plastic lip of
the servo before securing it with a screw and nut.
Then repeat for the opposite side.