Datasheet

Layout and Dimensions:
BBC micro:bit
Edge Connector
Klip Halo V2.0 Board for the BBC micro:bit
www.kitronik.co.uk/5648-BAT
80 mm
80mm
Introduction: The Klip Halo V2.0 board for the BBC micro:bit breaks out each of
the 19 GPIO pins from the BBC micro:bit, with easily accessible, clearly marked
connection points compatible with both crocodile clips and 4mm banana plugs.
The edge connector allows simple assembly by inserting the BBC micro:bit into
the Klip Halo V2.0. Detailed information regarding the uses of each micro:bit pin
can be found at: www.microbit.co.uk/device/pins
Power Supply:
The Klip Halo V2.0 with battery cage has an integrated 2xAA battery holder and
an on/off switch. The switch also turns on /off the power to the 3V connections.
19 Break Out, 3
GND and 3 +3V
Connections
2xAA Battery
holder
The Klip Halo board is 28.3mm thick
(including BBC micro:bit connector and Battery holder)
2x M3 mounting
holes
59 mm
Power Switch
Connecting a BBC
micro:bit:
The board has been
designed so that the
BBC micro:bit can be
slotted into the edge
connector.
No tools are required
for installation.
The blue arrow show
the direction of
insertion of the BBC
micro:bit.