User Guide

10
GENERAL SAFETY PRACTICES
The following safety instructions are addressed to both the operator of the machine as well as the person in
charge of maintenance.
The machine has to be delivered only in perfect conditions of use by the Distributor to the user. The user shall
operate the machine only after being well acquainted with the safety procedures described in the present manual.
READ THIS MANUAL WITH ATTENTION.
Basic Operation Procedures
Dangers
• Some areas of the electric device have parts that are connected or have parts connected to high voltage.
These parts when touched may cause severe electrical shocks or even be lethal.
• Given for each operation step. Every step of the operation shall be taken only if a sign has been made and
responded.
Advices
• In case of power shortage, immediately switch the machine off.* Use recommended or equivalent lubricants,
oils or greases.
• Avoid mechanical shocks, once they may cause damages or bad functioning.
• Avoid water, dirt or dust contact to the mechanical and electrical components of the machine.
• DO NOT change the standard characteristics of the machine.
• DO NOT remove, tear off or maculate any safety or identification labels stuck on the machine. If any labels
have been removed or are no longer legible, contact your nearest dealer for replacement.
Safety Procedures and Notes before Switching the Machine ON
Danger
An electric cable or electric wire with damaged jacket or bad insulation might cause electrical shocks as well as
IMPORTANT
If any recommendation is not applicable to your equipment, please ignore it.
IMPORTANT
Any change in the protection systems and safety devices will during operation,
create serious risks to the operator physical integrity.
IMPORTANT
Carefully read ALL INSTRUCTIONS of this manual before turning the machine ON.
Be sure to well understand all the information contained in this manual. If you
have any question contact your supervisor or your nearest Dealer.