User Guide

Table Of Contents

- 7 -

must be signed by the carrier representative (Driver), and contact the

carriers to pursue a claim within 15 days after receiving;

Be sure to install supporting legs before using, and do not tear up any label

or logo before normal using;

Please read these instructions carefully before installation and operation.

Please contact your local agent if you have any questions;

The equipment shall be installed on a level, solid, non-skid and

incombustible surface, and placed in a well-lighted work area with waterproof,

and away from children and customers;

The installation position is a well-ventilated place in accordance with the

local regulations;

The equipment must be installed under the matched cooking fume exhauster

according to the local regulations;

Important: Installation and ventilation laws, and codes are very different,

you should state and comply with all codes of the National Fire Protection

Association Inc when it comes to requirements for installation of equipment;

Install castors: screw them tightly with wrench, see Fig.1;

Adjustable stainless steel legs to make the equipment level, and get the same

level with other series of the same stove; Please lift the equipment rather

than drag if you need to move it;

Slipped over internal upper smokestack, screw it with a self-tapping screw;

Slipped over external upper smokestack, screw it with a self-tapping screw;

Put Hanging plate in front of the external upper smokestack;

Specific installation steps and methods read Fig.2 , Fig.3 , Fig.4;

Fig.1 Fig.2 Fig.3 Fig.4

Keep a distance of at least 6 inches(152mm) to equipment’s both sides and

back, and keep a distance of at least 4 inches(102mm) to the bottom;

Do not put anything around the equipment, and on the counter top and bottom,

in order to avoid influencing combustion and air circulation;

Thread glue must be resistant to the action of liquefied petroleum gases.

Warning! Use soap water or testing instrument to test whether piping joint

leaks or not before using, and forbid using an open flame to test!