User Manual

5) INSTALLATION INSTRUCTION

If the carton appears damaged, or damage is discovered once the carton is opened, stop

immediately and contact the freight company to file a damage claim.

CAUTION: The Steam Table is shipped without the legs, under shelf or cutting board

shelf attached. Please read the installation and operation instruction before operating

the unit. Remove all supports and packaging materials before operating the unit.

Failure to remove all packaging materials may lead to a fire and / or damage to the

appliance.

1. Remove all external packaging that is protecting top portion of unit

2. Remove all internal packaging to the unit, if present.

3. Visually inspect all external and internal portions of unit for damage.

4. Wipe down the exterior of the unit using a damp cloth with warm water. Do not use abrasive pads or

cleaners as they will damage the stainless steel surface.

Note: Ambient Conditions - Make sure that the operating location is in an area where the

ambient temperature is held constant (minimum 70°F). Please avoid areas such as near exhaust

fans and air conditioning ducts.

Warning! Operating environment

Ensure that operation location is at a reasonable distance from combustible walls and materials

otherwise combustion or discoloration could occur.

Caution! Operating environment

Place unit on a stable, level floor. The unit must be level, both front and back and left to right, in

order to maintain an equal water depth throughout the wells. To eliminate rocking or adjust

height turn the adjustable feet in the proper direction until the desired results are obtained.

Note: Maximum adjustment is 1 inch

5. Before plugging unit into wall outlet or permanently electrical connecting, the unit should be

adjusted to the desired height and align with other equipment.

6. The voltage and wattage ratings of this steam table are given on the device nameplate. Connect the

steam table to a circuit having a voltage and type of current similar to that stamped on the device

nameplate. For movable equipment a proper cord and plug are included for connection to the

matching power supply outlet.

7. Plug unit into grounded electrical outlet with correct voltage, and plug configuration.

a. Warning! Using any receptacle that is not designed to match the attached cord and plug

MAY cause personal injury and WILL void your warranty. Please attach the Steam Table, to

an individual branch circuit

8. For permanent installations, connections to supply line may be made through conduit or armored

cable. Use copper wire for power supply or suitable copper to aluminum wire connector.

9. The body of the appliance should be grounded by connecting the ground stud provided in the

junction box to a good electrical ground.

10. The steam table is not fused and consequently must be connected to a fused circuit equipped with

suitable disconnect means, as required by local code authorities.

11. To assembly the units follow steps 1 thru 6 listed below.