Manual

ENGLISH
CARE AND CLEANING | 9
1
To clean the blender base and cord:
Unplug the Blender before cleaning.
Wipe the base and the cord with a
warm, damp cloth; wipe clean with a
damp cloth, and dry with a soft cloth.
2
Make sure to clean the blender jar,
lid and ingredient-measuring cap
after each use. Remove any remaining
contents from the blender jar. Fill 1/3
of the blender jar with warm water
and add 1 drop of liquid detergent.
Place the lid on the blender jar, and
make sure the blender jar is fully in
place on the blender base.
3
Rotate the control dial to the Clean
program. Flip the START/STOP
toggle switch up or down. When the
program finishes, pour out the soapy
water, and rinse the blender jar with
warm water.
4
The blender jar, lid, Flex Edge tamper,
and ingredient-measuring cap are
dishwasher safe; the Flex Edge
tamper, lid, and ingredient-measuring
cap should be placed in the top rack
of the dishwasher. If preferred, all
parts may also be washed by hand
with a damp cloth and warm soapy
water, and then rinsed with warm
water and dried with a soft cloth.
CARE AND CLEANING
CLEANING THE BLENDER AND ACCESSORIES
Clean the Blender thoroughly after every use.
NOTE: To avoid damaging the Blender, do not immerse the blender base
or cord in water. To avoid scratching the Blender, do not use abrasive cleansers
or scouring pads.
NOTE: The handle grip can remain
on the handle of the blender jar during
cleaning and dishwasher cycles. If needed,
the handle grip can be removed to run
through the dishwasher separately and
then replaced.
W10886807A_EN_v02.indd 9 6/23/16 10:12 AM