instructionsheet-w10715277-reva
— 2 — W10715277 A
8. Once both clips are installed, the next step is to install the
adjuster body. To do this, you need to align thin edge with
the slots within the adjuster body. See Figure 6.
9. Next, the adjuster actuator needs to be installed. The actuator
needs to have the thumb pad facing the front of the rack for
correct/optimal adjuster operation. There are two (2) half
circle cut-outs on the adjuster body that will hold the actuator
in place. See Figure 7.
10. With the adjuster actuator resting inside the adjuster body,
the entire adjuster arm assembly can be pushed up against
the vertical tines. You should see that four (4) half circle cut-
outs on the adjuster body line up with specic tines. This will
conrm that everything is in its proper place. See Figure 8.
11. With the adjuster arm assembly resting against the vertical
tines and actuator installed, the adjuster cover can be
installed. To do this, a tab at the top of the adjuster cover
must be slid into a slot at the top of the adjuster body. With the
tab resting in the slot, the cover can be rotated and snapped
into the adjuster body. There will be a small exible tab that
will temporarily hold the cover in place before the screws are
installed. See Figure 9.
© Whirlpool Corporation 2014
(All Rights Reserved)
12. Drive the two (2) screws into the adjuster body. This will
complete the assembly of the rack adjuster. See Figure 10.
FIGURE 7
THUMB PAD
FIGURE 6
SLOTS
FIGURE 9
13. Repeat steps for second adjuster on opposite side of upper
rack.
14. Replace rack in dishwasher and verify function of rack with
new adjusters.
FIGURE 10
SCREWS
FIGURE 8