instructionsheet-w10715277-reva

Instruction Sheet
for Adjuster Kit
NOTE: These instructions only apply to the adjusters contained in this kit.
Instruction Sheet W10715277 Rev. A 6/14
5. To begin assembling the positioner clips, they need to be
rotated slightly to t between the rack tines. See Figure 3.
— 1 —
(continued)
4. Once the vertical portion is between the tines, rotate the
adjuster arm so that it lays parallel/at to the side of the upper
rack. See Figure 2.
Kit Contains:
2 Adjusters
1 Instruction Sheet
7. Once the clip is pushed down on the metal tabs, a small tab
will deect and lock the clip to the metal tab. See Figure 5.
FIGURE 2
FIGURE 3
6. Once the clips are rotated to the position shown below, there
will be two (2) slots [only one(1) is showing in this picture]
that align with the vertical metal tabs on the adjuster arm.
The clips need to be pushed down so that they seat over the
vertical metal tabs. See Figure 4.
FIGURE 4
SLOT
TAB
FIGURE 5
LOCKING TAB
1. Remove upper rack from dishwasher.
2. Remove old adjusters from rack.
3. To replace with new adjuster, begin by sliding the vertical
portion of the adjuster arm between the 4th set of vertical
tines (from the back of the rack). The adjuster arm will have
to be rotated slightly to t between the tines. See Figure 1.
FIGURE 1
1
43
2
VERTICAL PORTION
OF ADJUSTER ARM