Installation Instructions

Table Of Contents

Install In-Line Smart Kit

KVWB40DS Series Range Hoods

Remove Blower Motor from Range Hood Housing

1. Disconnect power.

2. Using two or more people, place the range hood on its back.

Be sure to set the range hood on a covered surface.

3. Using the T10 Torx

adapter, remove the 8 screws securing

the bottom panel to the range hood. Remove the bottom

panel and set it aside.

4. Using the T10 Torx

adapter, remove the 4 screws from the

blower motor cover plate. Remove the cover plate from the

motor and set it aside.

Disconnect the blower motor from the range hood wiring. Press

the top and bottom clip of the 9-pin electrical connector to

disconnect.

6. Using the T20

Torx

adapter with a long extension, remove

the 6 screws that secure the blower motor and insulation

retainers (2) to the range hood housing. Set the screws and

insulating retainers aside.

A. Bottom panel

B. Screws (8)

C. Range hood

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

WARNING

Excessive Weight Hazard

Use two or more people to move and install

range hood.

Failure to do so can result in back or other injury.

A. Blower motor cover plate

B. Screws (4)

C. Range hood

A. Blower motor

B. Screws - insulation retainer (2)

C. Insulation retainers (2)

D. Screws - blower motor mounting (4)