Installation Instructions

Table Of Contents

Install In-Line Smart Kit

WVW75UC and WV175UC Series Range Hoods

Remove Blower Motor from Range Hood Housing

1. Disconnect power.

2. Using two or more people, place the range hood on its back.

Be sure to set the range hood on a covered surface.

Open the stainless steel panel. Grasp panel at the left corners

and pull down to disengage the 2 catch pins from the spring

catches. The panel is attached at the right and will rotate down.

4. Remove the metal grease filter by pulling the spring release

handle and then pulling down the filter.

5. Remove the 2 screws securing the insulating retainer to the

blower motor and set them aside.

6. Disconnect the blower motor from the range hood wiring.

Using a flat blade screwdriver, and press down on the top clip

of the 9-pin electrical connector while pressing the bottom

clip. Unplug the blower motor from the 9-pin connector.

7. Using the T20

Torx

adapter with a long extension, remove

the 4 screws, 4 steel washers and 4 rubber washers that

secure the blower motor to the range hood housing and set

them aside.

8. Using the T10 Torx

adapter, remove the 7 screws securing

the plastic electrical box cover to the range hood. Remove

the cover and set it aside.

A. Spring release handle

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

WARNING

Excessive Weight Hazard

Use two or more people to move and install

range hood.

Failure to do so can result in back or other injury.

A. Blower motor

B. Screws, steel washers, and

rubber washers(4)

A. Plastic electrical box cover

B. Screws (7)