Installation Instructions

Table Of Contents

8. Connect the 9-pin connector from the blower motor to the

9-pin connector inside the in-line base.

9. Slide the in-line housing inside the in-line base. Align the

mounting holes in the in-line housing to the mounting holes in

the in-line base. Secure with the 4 screws removed when the

in-line housing was removed from the in-line base. Use the

T20

Torx

adapter to secure the screws.

10. Install the vent transition with a backdraft damper to the top

of the in-line housing. Use the T10 Torx

adapter and install

2 - 3.5 x 9.5 mm mounting screws to secure the transition to

the housing

Install In-Line Smart Kit

The In-Line Smart Kit must be installed to a secure structure of

the roof, ceiling, wall, or floor. The In-Line Smart Kit may also be

installed into a new or existing frame construction.

1. Using two or more people, position the assembled In-Line

Smart Kit (housing, base and mounting bracket) in its final

mounting location.

2. Use a pencil to mark the location of the 4 mounting holes.

3. Drill 4 mounting pilot holes where marked.

4. Install the In-Line Smart assembly in its final location using

4 - 5 x 45 mm screws.

A. In-line housing

B. Vent transition (with backdraft damper)

C. 3.5 x 9.5 mm screws (2)

A. Mounting screws (4)

B. Secure structure (joist, rafters or trusses)

C. In-line smart assembly

WARNING

Excessive Weight Hazard

Use two or more people to move and install

range hood.

Failure to do so can result in back or other injury.