Installation Instructions

20
14. Remove the 2 electrical knockouts from the top of the range
hood electrical box and install a UL listed or CSA approved
plastic strain relief into the front knockout.
15. Remove the 9-pin connector inside the range hood electrical
box. Insert a flat-blade screwdriver into the lateral clips while
removing the connector (see the following illustration).
16. Cut the wire tie that is closest to the 9-pin electrical connector.
17. Mount the cover plate supplied with the In-Line Smart Kit to
close the opening in the electrical box.
NOTE: Bend the cover plate along the perforation so it
conforms to the shape of the electrical box.
18. Run the 3 electrical power wires (black, white and green) and
the cover plate ground wire (green) through the small
electrical knockout in the top of the range hood electrical
box. Secure all 4 wires with 1 - UL listed or CSA approved
wire clamp. Snap the wire clamp into the electrical knockout.
19. Run the 9-pin pigtail electrical connector through the UL
listed or CSA approved strain relief.
NOTE: The 9-pin connector must be inside the range hood
electrical box.
20. Connect the 9-pin connector installed to the 9-pin connector
on the inside of the range hood electrical box.
21. Reinstall the plastic electrical box cover. Use the T10 Torx
®
and the screws previously removed.
A. Wire tie
B. 9-pin electrical connector (wires)
A. Opening
B. Cover plate
C. Cover plate ground wire
A
B
A
C
B
A. Electrical power wires (4)
B. UL listed or CSA approved wire clamp
C. Range hood electrical box
A. UL listed or CSA approved strain relief
B. 9-pin pigtail electrical connector
C. Range hood electrical box
A
B
C
A
B
C