Installation Instructions

18
Install In-Line Smart Kit
JXW85DS, JXI85DS, KVWB60DS, and KVIB60DS Series Range Hoods
Remove Blower Motor from Range Hood Housing
1. Disconnect power.
2. Using two or more people, place the range hood on its back.
Be sure to set the range hood on a covered surface.
3. Open the stainless steel panel.
4. Using the T10 Torx
®
adapter remove the screws securing the
filter retainer panel to the range hood. See the following
illustrations for screw locations and numbers.
JXW85DS and JXI85DS Range Hoods
KVWB60DS and KVIB60DS Range Hoods
A. Stainless steel panel
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
WARNING
Excessive Weight Hazard
Use two or more people to move and install
range hood.
Failure to do so can result in back or other injury.
A
A. Range hood
B. Filter retainer panel
C. Screws (6)
A. Range hood
B. Filter retainer panel
C. Screws (12)
C
A
B
A
B
C