Installation Instructions

14
11. Install the metal terminal box supplied with the In-Line Smart
Kit to the top of the range hood using 2 - 3.5 x 6.5 mm
mounting screws.
12. Reinstall the blower motor cover plate and bottom panel. Use
the T10 Torx
®
adapter and the screws previously removed.
Assemble the In-Line Smart Kit
1. Using the T20
®
Torx
®
adapter, remove the 3 screws from the
terminal box cover on the in-line housing. Set the screws and
cover aside.
2. Disassemble the in-line housing from the in-line base. Using
the T20
®
Torx
®
adapter, remove the 2 screws from inside the
terminal box near the top and the 2 screws located on the
opposite side. Lift the housing off the base and mounting
bracket.
3. Install the vent transition without a backdraft damper to the
bottom of the in-line base. Use the T10 Torx
®
adapter and
install 2 - 3.5 x 9.5 mm mounting screws to secure the
transition to the base.
4. Place the blower motor inside the in-line housing.
5. Engage the blower motor spring tabs into the keyhole slots
located at the top of the in-line housing. Push the motor so the
spring tabs are secured into the small neck of the keyhole slots.
6. Locate the 4 screws removed from the blower motor. Use
these 4 screws to secure the motor to the in-line housing.
Tighten with the T20
®
Torx
®
adapter.
7. Place the in-line housing (with blower motor installed) near
the in-line base.
A. Terminal box cover
B. Screws (3)
A. In-line housing
B. In-line base
C. Screws (4)
A
B
A
B
C
C
A. In-line base
B. Vent transition (without backdraft damper)
C. 3.5 x 9.5 mm screws (2)
A. Keyhole slots
A. In-line housing
B. Blower motor
C. Screws (4)
A
B
C
A
B
C
A