Use and care guide
10
FUNCTIONS
BAG VACUUM MODE
1. Push to open the drawer.
2. Press the
button for 2 seconds to exit the energy saving state.
3. Open the lid, making sure the vacuum chamber is dry. When placing food in the bag, take
care not to get the bag dirty or wet next to the opening, as this could
result in an ineffective seal.
4. Place the bag, centred on the sealing bar, in a way that the open
edge projects by about 2 cm with respect to the bar itself.
5. Make sure that the edges are positioned on the bar without any
wrinkles or folds.
6. Close the lid and hold it down while at the same time selecting the
bag cycle. Keep the lid pressed down for a few moments. In this way
the lid will remain shut and tight to the seal for the duration of the
cycle.
7. Press
to select the Vacuum bag cycle.
8. Tap
to set the desired sealing level (you can select three different
levels). The higher the level of sealing chosen, the longer the sealing
time (see the Sealing Mode paragraph below).
For the preservation of food and for vacuum cooking, the use of level 2 or 3 is
recommended.
9. Press . The Vacuum bag cycle is started. An acoustic signal (short
beep) is emitted on cycle start and at the end.
7 SPECIAL FUNCTIONS FOR COOKING
The average time of these cycles varies from 5 to 25 minutes.
Sauces and liquids in bags
Tomato sauce
Fruit juices and coulis
Syrups and concentrates (of wine, of vinegar)
Once the pack has been prepared inside the vacuum chamber as described in the
“Preparation” chapter, close the lid exerting a slight pressure on the front (follow the
previous steps from 1 to 6).
Note: liquid products must not occupy more than 1/3 of the volume of the bag.
1. Repeatedly press
till you select the Liquid into Bags cycle.
2. Tap
to set the desired sealing level. The higher the level of sealing chosen, the longer
the sealing time.
3. Press
, holding the lid lightly. The cooking vacuum cycle is started. An acoustic signal
(short beep) is emitted on cycle start and at the end.
The cycle proceeds automatically.
Every cycle can be stopped in advance by pressing the button . In this case, the machine
will not proceed with sealing and the chamber will be decompressed.
Wait for approximately 20 seconds and the acoustic signal before starting another cycle.