Owner's Manual

14
2. Remove each lter by pulling the spring release handle and
then pulling down the lter.
3. Wash metal lters as needed in dishwasher or hot detergent
solution.
4. Reinstall the lter by making sure the spring release handles
are toward the front. Insert aluminum lter into upper track.
5. Push in spring release handle.
6. Push up on metal lter, and then release handle to latch into
place.
7. Repeat steps 1 to 5 for the other lter.
8. Close the stainless steel panel. Engage the 2 pins in the
spring catches to secure.
Non-Vented (Recirculating) Installation Filters
The charcoal lter is not washable. It should last up to 6 months
with normal use. Replace with Charcoal Filter Kit. See the
“Accessories” section for information on ordering.
To Replace Charcoal Filter:
1. Remove metal grease lter from range hood. See “Metal
Grease Filter” in this section.
2. Bend spring clips away from metal grease lter.
3. Place charcoal lter into top side of metal lter.
4. Bend spring clips back into place to secure the charcoal lter
to the metal lter.
5. Replace metal grease lter. See “Metal Grease Filter” in this
section.
NOTE: When used in recirculation mode, To reduce the Risk of
Fire and Shock use only conversion kit Model W10692910.
Replacing a Halogen Lamp (Ambient Lighting)
Turn off the range hood and allow the halogen lamp to cool. To
avoid damage or decreasing the life of the new lamp, do not
touch lamp with bare ngers. Replace lamp, using tissue or
wearing cotton gloves to handle lamp.
If new lights do not operate, make sure the lamps are inserted
correctly before calling service.
1. Disconnect power.
2. Using a at-blade screwdriver, gently pry the light cover
loose.
3. Remove the lamp and replace with a 120 V, 40 W maximum,
halogen lamp made for a G-9 base.
4. Replace the light cover.
5. Reconnect power.
Replacing a LED Lamp
The LED lights are replaceable by a service technician only. See
“Assistance and Service” section for service contact information.
A
A. Spring release handle