Setup and user guide

7
EN
Finish in
Enables to have the laundry ready at a particular time by
setting a delay until end of the programme.
• Select programme and options.
• Press the “Finish in” button – “Finish in --:--” appears on the display.
• Press the UP or DOWN keys to select a delay up to 23:30 hours.
• Press “Start / Pause” - the countdown of the delay starts. The
display indicates the default programme duration of the selected
programme in the rst line, and the selected “Finish in” period until
programme end in the second line.
• The programme starts automatically, in time to be nished at
the end of the selected “Finish in” period. The second line on the
display keeps on indicating the countdown of the time until end
of the programme.
To cancel the delay
• either press “Start/Pause” to cancel the delay. To start the selected
programme immediately, press “Start/Pause” again .
• or press and hold “On/O” to cancel the complete programme
setting.
INDICATORS
Failure
For any failures, refer to section TROUBLESHOOTING in the USE AND
CARE GUIDE.
Energy monitor
Gives feedback about the energy consumption of the programme
setting.
The less indicators light up, the more economic is your programme
setting.
CARE AND MAINTENANCE
Switch off and unplug the dryer before doing any cleaning and maintenance.
Caution, the water in the water tank can still be hot.
• Empty water tank after each drying cycle
Hold the handle and carefully pull out the water tank. Hold the
full water tank with both hands. Empty the water and insert the
container by pushing it back into place. Make sure that it is properly
inserted.
• Clean door lter after each drying cycle
Open the door and remove the door lter by pulling it upwards.
Press the button to open the door lter. Remove the lint inside.
Close the lter and reinsert it in the right direction, so that it
completely integrates in the lter chamber.
• Clean the bottom lter after about every fth drying cycle
Open the bottom ap. Hold the handle and pull out the bottom
lter.
Remove the foam from the bottom lter, to clean it. Clean the lter
foam and the lter by hand or under running water. Do not wash the
lter foam in the washing machine. Wring out the lter foam. Do not
insert it in the bottom lter dripping wet.
Fix the lter foam on the bottom lter. Clean the lter chamber of
the dryer with a damp cloth or carefully with a vacuum cleaner.
Insert the bottom lter again. Clap the lter handle down and close
the bottom ap.