Manual

Whirlpool - CIC 8/16/04 2:25 PM PAGE 1/21 RightFax
Foreasier installation, it is
recommended that both the
120-volt supply wiring to be
connected to the hood liner wiring
box and the exterior blower
system be instal[ed first. Pull
enough wiring through the wall to
allow for making the electrical
connections at the hood liner
wiring box. Label which cable is
the 120-volt supply wire and
which is the exterior blower cable.
Cover countertop or cooking
surface with a thick, protective
covering to prevent damaging
them.
2-3/4" 5-15/16"
{7.0ore) (1511cm)
l
i \ I\ i\ \ \ \ \ \ \_ _\ \i\ \ \ \
O 4,
i i
i ................
-I ............I...............7"
17-5/16" 11"(2Z9cm) 5/16"(7.9mm)
(40.0cm) dia. dfa.4-holes
hood size A B
36"(91,4cm) 31-7/16" 15-23/32"
(79.9cm) (39.9cm)
48"(121.9cm) 43-7/16" 21-23/32"
(110.3cm) (55.2cm)
= Markthe Iocationsof four
5/16" (7.9 ram) dia. holes and an 11"
(27.9 cm) dia. holeas shown. Use a
compass or template and markthe
outlineofthe 11" (27.9 cm) hole.
= Drill the four holesand, usinga
saber saw or keyhole saw, cut the
11" (27.9 cm) dia. hole.
2 _
hood 14-3/16" (5.1ore)
oooo ,E--h-
onwall
= Drilla 1-1/4" (3.0 cm) dia. hole
at location shownfor electrical
wiring.
. Removethe electrical
knockoutfromthe hood liner.
= Removethe filters.Use two
handsto removefilter.Pushtab
backto releasethe lockingpin, pull
downand forward. Set filter aside.
Repeat with otherfilter(s).
. Removethe wiring box cover
locatedbehind the right handfilter.
= Install U.L.- orC.S.A.- listed
strain reliefin hood liner sothat
screwscan be tightened,
Electrical
connection
Electrical Shock H==,ard
Disconnect power before
servicing.
Connect ground wire to green
ground screw in terminal box,
Failure to do so can result in
death or electrical shock.
. Disconnect power.
= If not previouslydone, run the
120-volt supply wiringto the hood
lineraccordingto electricalcodes
and ordinances.
0= Removethe four mounting
screwsfromthe parts bag. It is
recommendedthey be placed by
the holesin the hood linersupport
for quickaccess.
ExcessiveWeightH=ard
Usetwoor morepeopletomove
andinstallhoodliner.
Failureto do socan result in back
orotherinjuw.
I I
i I
I
I
1,Whilefeeding the wiring
throughthe strain relief,liftthe hood
linerinto place. Insert the screws
throughthe supportand thread into
the hood linerholes.Tightenscrews
SSCUrely.
2= Makethe wiringbox
electricalconnections.