Owner's Manual

9
Keypad Feature Instructions
Cook Auto cook For Cook Menu mode, it is not necessary to set the time and power,
follow the instructions below:
1. Press “Cook” button, the “P1” will show on the display.
2. Use +/- button or “Cook” to select a food category. See the Cook
Menu section in this guide for the food category or reference
sticker on the front plate of the microwave.
3. Press Start button.
Sensor Cooking: a sensor in the microwave oven detects humidity
released from the food as it heats and adjusts the cook time
accordingly.
(For non-sensor cooking, the display will show the default weight.
Press +/- button to adjust desired weight. Press the Start button.)
Soften Soften The Soften function is used to soften food. To use:
1. Press “Soften”, the display will show “P1”.
2. Use “Soften” button or +/- button to select a food category,
see the Soften Menu section in this guide for the food category or
reference the sticker on the front plate of microwave. Press Start
button to conrm.
3. Use +/- button to adjust the quantity.
4. Press Start button.
Melt Melt The Melt function is used to melt food. To use:
1. Press “Melt”, the display will show “P1”.
2. Use “Melt” button or +/- button to select a food category, see the
Melt Menu section in this guide for the food category or reference
the sticker on the front plate of microwave. Press Start button to
conrm.
3. Use +/- button to adjust the quantity.
4. Press Start button.
Keep Warm Keep Warm The function allows to keep your dishes warm. To use:
1. Press “Keep Warm” button, default time “30:00” will show on the
display.
2. Press “Keep Warm” or +/- button to select 15 min, 30 min,
45 min, or 60 min.
3. Press Start button.
NOTE: The Keep Warm cycle last for a duration of 15 minutes
(default 30 minutes), the maximum time is 60 minutes.
Each 15 minutes cycle, microwave will be turned on 1.5 minutes,
then cavity lamp and fan are off, only the countdown time is shown.
Steam Clean Auto cleaning cycle The cleaning cycle will help to clean the microwave oven cavity.
1. Place 1 cup of water (~250 mL) on the middle of the cavity.
2. Press “Steam Clean” button, default “13:00” time will show on
display.
3. Press Start button to start the function.
After nishing the heat-up cycle (3 minutes), the cavity lamp and
fan will be off and display will show the countdown time.
NOTE: Please follow Tips and Suggestions in Steam Clean section.
Tone ON/OFF Turn on or off beep sound The function allows to turn on or off the beep sound:
1. Press Steam Clean button and hold for 5 seconds to put into
mute, the Tone Off icon will be shown on display.
2. Hold the button again for 5 seconds to turn on the sound.