Manual

Non-Vented (recirculating) Installations
1. Connect the vent system to the range hood vent opening.
Seal the connection with clamps.
2. Install charcoal filters. See "Range Hood Care" section.
3. Replace metal grease filters. See "Range Hood Care"
section.
4. Reconnect power.
5. Check the operation of the range hood fan and light.
6. Push the range hood screen back in.
To order replacement kits, see the "Assistance or Service"
section.
Install Front Trim Kit
1. Pull out on the range hood screen for access to the screws.
2. Remove metal grease filters. See "Range Hood Care"
section.
3. Remove the 3 mounting screws directly behind the front
panel.
White, black and brushed aluminum front trim for matching the
front panel to your range or cooktop color are included with the
range hood. The white trim is installed. See following instructions
to install a different trim color.
A. Three mounting screws
4. Remove existing trim piece and insert new trim piece.
5. Attach the new trim piece to the front panel using the
3 mounting screws. Tighten the screws.
6. Replace the metal grease filters. See "Range Hood Care"
section.
7. Push the range hood screen back in.
RANGE HOOD USE
The range hood is designed to remove smoke, cooking vapors and odors from the cooktop area. For best results, start the range hood
before cooking and allow it to operate several minutes after the cooking is complete to clear all smoke and odors from the kitchen.
Fan Control Light Control
r
Operating the Fan
1.
2=
3=
0
1 !
3
Slide the range hood screen forward.
NOTE: When the screen is opened the fan will operate at the
fan switch setting that it was at when the screen was closed.
The fan will shutoff when the screen is about 2" (5.1 cm) from
the closed position.
To turn fan On, move the fan switch from 0 (Off) to the desired
fan speed, 1 (Low), 2 (Medium), 3 (High).
NOTE: The speed may be increased, decreased, or turned off
at anytime during the range hood operation.
To turn the fan Off, move the fan switch to 0 (Off) or close the
screen.
NOTE: The fan will shut off when the screen is about
2" (5.1 cm) from the closed position. When the screen is
opened, the fan will operate at the last setting.
Operating the Light
1. Open the range hood screen.
2. To turn light On, move the switch from 0 (Off) to 1 (On).
NOTE: If the light switch is left in the 1 (On) position, the light
will be on each time the screen is opened. It can also be used
as a night light by opening the screen about 1" (2.5 cm).
3. Move the light switch to the 0 (Off) position or close the range
hood screen to turn the light Off.
13